4200 SPI Single Stage Tech Sheet

AndyK

****
Staff member
Single Stage Polyurethane Color

Product:
#4200-1 - All colors


Mixing:
4:1 with any of the following activators:
2102-4 Medium
2103-4 Slow
2104-4 Very Slow

Paint gun tip:
1.4

Description:
A premium single stage paint that is easy to spray and may be wet sanded and buffed the next day after spraying (only if needed).

This single stage has very good chemical resistance and stone chip resistance.

Preparation:
Use normal preparations for paint and when ready to spray clean the vehicle with wax and grease remover 700 or 710, then let the vehicle set for 45 minutes before applying the single stage paint.

Application:
With properly adjusted gun spray one wet coat. When finished check time and wait exactly 30 minutes before spraying second coat, same with the third coat if needed.

The last coat of color can be integrated with any SPI pre-activated clear mixed with
pre-activated Single Stage, at any ratio although the most common is 50/50.

This single stage can also be cleared after setting overnight with any SPI clear and if done in 24 hours simply tack it and shoot it.

Buffing:
Next day wet sand, put the vehicle in sun for about 4 hours, pull it inside and when the vehicle cools buff as usual.
 
AndyK;21065 said:
Single Stage Polyurethane Color

Product:
#4200-1 - All colors


Mixing:
4:1 with any of the following activators:
2102-4 Medium
2103-4 Slow
2104-4 Very Slow

Paint gun tip:
1.4

Description:
A premium single stage paint that is easy to spray and will wet sand and buff very the next day after spraying (only if needed).

This single stage has very good chemical resistance and stone chip resistance.

Preparation:
Use normal preparations for paint and when ready to spray clean the vehicle with wax and grease remover 700 or 710, then let the vehicle set for 45 minutes before applying the single stage paint.

Application:
With properly adjusted gun spray one wet coat. When finished check time and wait exactly 30 minutes before spraying second coat, same with the third coat if needed.

The last coat of color can be integrated with any SPI pre-activated clear mixed with
pre-activated Single Stage, at any ratio although the most common is 50/50.

This single stage can also be cleared after setting overnight with any SPI clear and if done in 24 hours simply tack it and shoot it.

Buffing:
Next day wet sand, put the vehicle in sun for about 4 hours, pull it inside and when the vehicle cools buff as usual.


Not to be that guy but.... that reads a bit strange, no?

It's awesome to see new products come out at a very good pace.
 
Back
Top