DA for sanding before flow coats

bmenard

Member
Is anyone doing this? I’ve always done it by hand with 800 when doing 3 coats then three more. But wondering why 6 or 800 on an interface pad would not work just fine. 3 coats of euro on, putting 3 of universal on top. Euro is a week old.
 
I'll do it on motorcycle parts and golf carts, but if I am flow coating a car that I am trying to achieve a dead straight finish on, I will hard block with 600 and go from there.. The interface pad will roll over the texture and will not flatten it.

Also you have to be extremely careful when doing that. With an interface pad its very easy to roll over an edge and burn through.
 
Back
Top