Did I mess up bedliner application?

Arrowhead

Arrowhead

Oldtimer
I undercoated the entire underside of the fiberglass Cobra and everything went great and hardened up no problem. BUT, there were four small aluminum panels I also shot the next day and they are still soft. I think the problem was the panels were too cold (didn't pre heat the garage enough). It's been over two weeks and they are still soft. I thought heat might help so I put them in the boiler room where it's probably 80 degees but they are still kind of soft after about 5 days. Is that helping or should I just scrape it off and recoat? It really isn't a big deal if I have to redo them, they are flat and not very big.

(YES, I USED THE GEO GUN AND MIXED CORRECTLY)
 
Arrowhead;34505 said:
I undercoated the entire underside of the fiberglass Cobra and everything went great and hardened up no problem. BUT, there were four small aluminum panels I also shot the next day and they are still soft. I think the problem was the panels were too cold (didn't pre heat the garage enough). It's been over two weeks and they are still soft. I thought heat might help so I put them in the boiler room where it's probably 80 degees but they are still kind of soft after about 5 days. Is that helping or should I just scrape it off and recoat? It really isn't a big deal if I have to redo them, they are flat and not very big.

(YES, I USED THE GEO GUN AND MIXED CORRECTLY)
Click to expand...

Did they finally harden up or did you strip them?

Steve
 
You must log in or register to reply here.
Back
Top