Chris_Hamilton
Trying to be the best me, I can be
Just a quick question for Barry and everyone. Doing this Chevy P/U. The inside of the bed was typical of most trucks of that era. Lot of surface rust. Removed all surface rust and ended up using some Ospho. Neutralized it properly, then DA'ed it with 80 grit, then shot 3 coats of black epoxy. I am way past the 7 day re-coat window so I have been sanding the entire bed with 180 by hand. Had some deep pitting pretty much all over the bed floor. After sanding many of the pits are still shiny and I don't see any easy way to get to them. Only way would be to remove the epoxy in the pits with a wire brush which would be stupid I think. Will I have any issues if I re-epoxy over those pits? Keep in mind these are very small pits left by surface rust. Lots of sanded surface area around them.
Personally I don't think it will be an issue but since I'm sure some of you have run into the same issue I'd like to hear your thoughts. Thanks.
Personally I don't think it will be an issue but since I'm sure some of you have run into the same issue I'd like to hear your thoughts. Thanks.