Epoxy sealer

68fleetside

Promoted Users
From picture below, will sealer reduced 1:1:1 be fine over this sand through?
1020202110.jpg
 
Was sanded in 320 grit. I went ahead and sanded P600 wet. Do I just seal with epoxy 1:1:1 even though there are sand through, metal and a small body filler spot? Thank you
 
if I have a big metal spot like that, it would mean that the panel wasn't straight enough yet. So it would get more primer and blocking until that stopped happening, or a regrouping to see if the fender has deeper issues that got missed.
 
Worked on some spots and covered the bare metal and filler with epoxy 1:1:1, to light coats. Can I wet sand in morning and proceed to seal the rest?
1021201713a.jpg
 
Back
Top