Have a Mercedes hood with a few chips on the front edge.Feathered them out to bare metal and 180 the rest as hood has a poor repaint. Shot epoxy on the complete hood. Mixed 1 to 1 with a splash of med. reducer and induction of 1 hr. just a lot of fish eyes over most of the hood. Of course SPI epoxy and reducer. Have used SPI for years and never had this reaction. Asking opinions of some of you what should I do. Plan was to spray a few coats of 2K primer over the epoxy wet sand and then to base as I have done for years. Also my shop is in the high 60's temp wise. Thanks