Craigbro63
Promoted Users
Well, after much reading and following documented processes I am pretty satisfied with my first paint job. I used all SPI primers, cleaners, etc , Universal Clear, and Motobase paint.
The only issue after a few months, or at least that's when I noticed, I found a few spots with pinhead size bubbles that look to be under the paint. From reading throught posts I am guessing that this may be solvents that were trapped. Maybe wax/grease remover? I waited the recommended times between cleaning, paint coats, and clear coats.
I sanded some smooth with 2000 and polished. You can see that on some bubbles the primer is showing even before sanding.
Any suggestions on repairing?
FYI, I previously did a repair with the blending fluid process and while it's OK I find that it came out a little lighter than the original paint.
Thanks!
The only issue after a few months, or at least that's when I noticed, I found a few spots with pinhead size bubbles that look to be under the paint. From reading throught posts I am guessing that this may be solvents that were trapped. Maybe wax/grease remover? I waited the recommended times between cleaning, paint coats, and clear coats.
I sanded some smooth with 2000 and polished. You can see that on some bubbles the primer is showing even before sanding.
Any suggestions on repairing?
FYI, I previously did a repair with the blending fluid process and while it's OK I find that it came out a little lighter than the original paint.
Thanks!