RosharonRooster
Promoted Users
good morning. On Friday I had to repaint a section on my car. This was my process.
Was about 90 degrees.
Fixed repair area. Sanded the section with red pad.
3 coats off DBC 15 mins between coats. 30 mins between last coat and first coat of clear.
Production clear iwata lph 35 psi. Slow activator. Laid down nice. Dust nibs as usual.
25 mins later....2nd coat...same process...
35 mins after that....3rd coat same process...
Looked great. Was excited. Turned off fan Go outside to clean my guns come back in 30 mins and there is this area of these tiny bubbles.
Any suggestions to what happened and how to fix this. Hopefully wet sand them out?
I've never had this happen. Nothing changed in my process or equipment. And it didn't happen immediately. Happened after I was done. And its only in random areas not entire panel.
Was about 90 degrees.
Fixed repair area. Sanded the section with red pad.
3 coats off DBC 15 mins between coats. 30 mins between last coat and first coat of clear.
Production clear iwata lph 35 psi. Slow activator. Laid down nice. Dust nibs as usual.
25 mins later....2nd coat...same process...
35 mins after that....3rd coat same process...
Looked great. Was excited. Turned off fan Go outside to clean my guns come back in 30 mins and there is this area of these tiny bubbles.
Any suggestions to what happened and how to fix this. Hopefully wet sand them out?
I've never had this happen. Nothing changed in my process or equipment. And it didn't happen immediately. Happened after I was done. And its only in random areas not entire panel.