B
Bennett Bryner
Not sure where to post this but... In my current situation, my compressor is in an attached, non-heated garage, and about 30ft of 1/2 line goes to my detached garage where I spray. Now that the temps have been freezing or below, I noticed that my water trap has had zero water in it. I have heard that the air temp must be higher than outside air temp for the water to condense, which isnt happening until it leaves the gun.
Where the main feed line goes in to the heated, detached garage, there is a water/oil separator, then a RTI MD4 desiccant filter, then 25ft 3/8" flexzilla to the gun.
Any issue running cold air through the gun? Should I insulate my feed line from the compressor? Once the line hits the detached garage, should I run a hard line around the garage to allow the air to heat up before hitting the dryer/separator?
Thanks for all the help!
Bennett
Where the main feed line goes in to the heated, detached garage, there is a water/oil separator, then a RTI MD4 desiccant filter, then 25ft 3/8" flexzilla to the gun.
Any issue running cold air through the gun? Should I insulate my feed line from the compressor? Once the line hits the detached garage, should I run a hard line around the garage to allow the air to heat up before hitting the dryer/separator?
Thanks for all the help!
Bennett