Trunk Skin Bonding

JimKueneman

Mopar Nut
Was getting depressed about the Dart once I started blocking the trunk lid..... It oil canned and I thought it was warped beyond recovery..... but I noticed that all the goop that bonds it to the bracing has broken loose so there is no support for it.....

How do I fix this? What do I use to bond it back down to the substructure?

Never mind here we go:


Jim
 
Last edited:
I used 3M 4274 Duramix NVH sealer when reassembling the hood for the GTX. Worked great and I will use it again when installing the roof skin.
 
Is one of those enough to reattach the trunk and run a few reinforcement blobs on the hood as I am sure they are getting ready to go as well. They are just dried out.
 
Is one of those enough to reattach the trunk and run a few reinforcement blobs on the hood as I am sure they are getting ready to go as well. They are just dried out.

Should be plenty for a trunk lid. Remember if you decide to use it, you'll need a 200ml dual cartridge gun to apply it with. Something like this:

https://www.ebay.com/itm/JES-Innova...st-Dual-Component-Cartridge-Gun-/263894180495

or this
 
Back
Top