What is this connection, how do I adapt to my air system?

[jtfx6552]

Is there an adapter to NPT so I can but a QD on the end of this hose to plug into my normal air hose where I plug in all my other spray guns?

 

[Worn Out Welder]

I just cut the hose and used a 1/4 npt female x 3/16” hose barb ( or whatever I’d of that hose is…..of course it’s handy to have an assortment of ferrells for torch hose and a crimping tool
About what you’d expect from a welder

 

[Worn Out Welder]

I just checked and the threads are the same pitch
Just screwed it together ….should work without much fuss

 

[MJM]

Is that hose for an Airbrush?

 

[Jim C]

thats it. just a regular1/4" npt air fitting threads on to the hose.

@MJM yes, airbrush hose

 

[MP&C]

Your quick disconnect fitting should screw right in place.

 

[jtfx6552]

Ok, I'm good to go, what pressure do air brushes like? I have a Paasche I believe the model is a MIL.

All I'm doing with this is fixing the bottom of my car. I had sprayed all the various overspray patterns on the bottom of my shell. Then dropped the car on the body cart and put in a bunch of scratches. I brushed on some epoxy, then brushed on the black that matches the bottom, now I need to put some white overspray right on the tiny repaired areas.

 

[Worn Out Welder]

https://3372523.app.netsuite.com/core/media/media.nl?id=17877&c=3372523&h=KXiN0ZvQfyfVJGCq3_G-Kww_Nt4SB1sBeSI8bDVbZLW_tQZh&_xt=.pdf

 

[Worn Out Welder]

That was a pdf for a MIL paasche model

 

[Jim C]

Ok you need a regulator for an airbrush not a valve.

 

[jtfx6552]

Thanks! That valve is wide open, I do have a regulator on the wall.

Ok you need a regulator for an airbrush not a valve.