Schroeder
Promoted Users
I am planning on NOT reinstalling trim, but if I run into fitment issues with the modern rubber trim seal I have I may just put the old trim on. I replaced quarters and roof skin, so the OEM trim rivets are gone. I don't wanna buy the spot welder if I don't have to. These are copper coated steel. Is there any reason I can't wire brush the copper off these and TIG them to my panels? I'll never use the spot welder again and don't wanna mess with it.
Motor Guard - Rivets 500 Per Bag (J20012) https://a.co/d/bYNfGrW
Motor Guard - Rivets 500 Per Bag (J20012) https://a.co/d/bYNfGrW