Can spout

S

Steves69LS3

Hey guys,
Do they sell pouring spouts for the gallon activator type cans?
I seem to spill alot when pouring a newly opened can

Thanks
 
keep an old lid and cut a small hole in it. i also use a large sheet metal screw and a tooth pick in a gal lid.
 
ahh good idea!
then i can just fit a spout from a 5 gallon and use that :)
 
the acc lids i drill a small hole in. when i get a gal of epoxy or such i put the screw in the lid then after stirring i put it back on. some times i mix small amounts , 1/2 cup or so .
 
Another tip is to wipe the inside lip down and use 2" tape around the lip as an extension. It will work on reducer and activator cans as well, after you take the lid off, wipe down the inside of the spout and stick a piece of tape on it about half way around the inside of the spout. JcClark is the one that told me about it (I felt stupid for not thinking of such a simple solution myself, just as I did when I rea how Shine does his lids).

Here's a link with a picture (forgive me for the HR source I can't save pictures on the work computer) http://www.hotrodders.com/forum/attachment.php?attachmentid=75388&d=1372870207

Kelly
 
Yea never been a fan of the tape trick. Too bad they just dont make a screw on spout for the rectangle cans
 
all I do is turn the can sideways or longways and that helps with the pouring
 
You must log in or register to reply here.
Back
Top