B
bomccorkle
I was assembling a hood and the cowl on a truck I've been working on, any who I got impatient with them and pushed a bit to hard lining up and had one spot chip in each of them, I'm not sure if I can spot repair them, I've tried blending and I'm just not any good at it....
So I was wondering if anyone had a method to spot repair?
Barring that, I'm not opposed to removing them and going ahead and reshooting them but if that's the case can anyone give me a recommended step by step, its SPI black base and UV clear, I think I have just about every activator on hand and some polar accelerator too, I'd like to be able to spray in the morning and be buffing in the afternoon if at all possible?
Thanks for any help guys and next time I'll use 2-3 layers of tape instead of just one.... And definitely be a bit more ginger.....
Forgot to mention that the high around here tomorrow will be about 75, I doubt but about 60-65 when I start spraying and its rained today so fairly high humidity tomorrow as well.
So I was wondering if anyone had a method to spot repair?
Barring that, I'm not opposed to removing them and going ahead and reshooting them but if that's the case can anyone give me a recommended step by step, its SPI black base and UV clear, I think I have just about every activator on hand and some polar accelerator too, I'd like to be able to spray in the morning and be buffing in the afternoon if at all possible?
Thanks for any help guys and next time I'll use 2-3 layers of tape instead of just one.... And definitely be a bit more ginger.....
Forgot to mention that the high around here tomorrow will be about 75, I doubt but about 60-65 when I start spraying and its rained today so fairly high humidity tomorrow as well.