P
Pope
This is a spring that holds the hood of my car up. The long tab that points up, is in the stationary position. When you close the hood, the hood forces the tab down (to the left) a little less than 90°. That tab is about 12" high and the spring width is about 36". Do you think I would have a problem painting it with epoxy, and it holding up to the bending force?
Also, I plan on doing the same with the wheel springs at all four corners. Regular spring where the shocks are mounted inside them.
Am I OK to do this?
Thanks guys
Also, I plan on doing the same with the wheel springs at all four corners. Regular spring where the shocks are mounted inside them.
Am I OK to do this?
Thanks guys