A
abarli65
Spraying SPI white epoxy reduced 1:1:1
I have read that some guys will finish their 2K with 320 grit if spraying solid base. I will be spraying Prospray red base coat followed by SPI universal clear.
So far it is looking great on the under sides of my panels. As for the money side, I notice that I can still see the 320 sand scratches in my epoxy sealer coat...
At this point, do I:
1. Spray my base as the 3 coats should cover in those scratches.
2. Spray more coats of reduced epoxy until it fills the 320 scratches.
3. Spray full strength of epoxy to fill scratches, wet sand with 600, then shoot again with reduced epoxy.
Shooting epoxy with Finex 3000 1.4 tip at 28lbs at the inlet and 2.5 turns out full fan
Shooting base with LPH400 1.4 tip with orange cap at 16-18 lbs at the inlet 2.5 - 3 turns out full fan
Shooting clear with LPH400 1.4 tip with silver cap at 16 - 20 lbs at the inlet 3 to 4 turns out full fan
I have read that some guys will finish their 2K with 320 grit if spraying solid base. I will be spraying Prospray red base coat followed by SPI universal clear.
So far it is looking great on the under sides of my panels. As for the money side, I notice that I can still see the 320 sand scratches in my epoxy sealer coat...
At this point, do I:
1. Spray my base as the 3 coats should cover in those scratches.
2. Spray more coats of reduced epoxy until it fills the 320 scratches.
3. Spray full strength of epoxy to fill scratches, wet sand with 600, then shoot again with reduced epoxy.
Shooting epoxy with Finex 3000 1.4 tip at 28lbs at the inlet and 2.5 turns out full fan
Shooting base with LPH400 1.4 tip with orange cap at 16-18 lbs at the inlet 2.5 - 3 turns out full fan
Shooting clear with LPH400 1.4 tip with silver cap at 16 - 20 lbs at the inlet 3 to 4 turns out full fan