I see lots of panels being painted where one side is painted first then masked off while the other side is painted.
How exactly does one handle the edge of the panel?
First, should the second side be painted while the panel is till in the recoat window? Seems like that would be best if it wan't impossible, I.e. if your in the recoat window, how can you mask it?
If your not in the recoat window then you need to sand, so how do you sand right up to the edge of where you are going to paint without leaving either a weird looking edge or an edge not sanded with potential adhesion issues?
Or am I just over thinking this?
How exactly does one handle the edge of the panel?
First, should the second side be painted while the panel is till in the recoat window? Seems like that would be best if it wan't impossible, I.e. if your in the recoat window, how can you mask it?
If your not in the recoat window then you need to sand, so how do you sand right up to the edge of where you are going to paint without leaving either a weird looking edge or an edge not sanded with potential adhesion issues?
Or am I just over thinking this?