G
Grabbit
I was reading the manual for my compressor and is says to use 1/2 hard lines for anything under 50ft and 3/4 for anything over. Is the performance or CFM going to drop if I use 1/2 over 50ft? Copper piping is about 50% more expensive between 1/2 and 3/4 inch. A 10ft section is $10 for 1/2 versus $15 for 3/4. I know my compressor is already a bit under powered from what I've read on here. It is a Husky 60gal single phase 13.4 CFM@40psi, 11.5@90psi. I plan on using low CFM guns an going slow. I'm also shooting small VWs not 50s Cadillacs. Any thoughts?