cmfisher4
Promoted Users
I'm (maybe) finished the metalwork/epoxy/filler/primer stages with my first panel (passenger's door; it was a steep learning curve). I finished up with three coats of 2K regular build primer and I'm happy with how straight it is. Unfortunately, during my final sanding, I found three small high spots, about the size of a quarter, where I got through to bare metal. It is acceptable to flatten those spots a bit and do another few coats of 2K to get those areas covered, or should I hit the entire door with 2 coats of epoxy again, then 2K? I'm not particularly concerned with imperfections as they are all on the bottom of the door and, give the size of the car (Triumph Spitfire), they would be very hard to see, but I am trying to do a proper job. Thanks!