The outside was stripped, body worked and primed. Blocked out like all stars. Then we flipped and stripped the undersides with 80g d/a (hindsight-probably should have done underside before top side bodywork). Felt the "dents". Cut the glue tabs. Better. Blocked with 120 til we found our highs, then glazed the whole thing and re-primed. Again, blocked out great. Paint. Dents. Buffing heat seems to dramatize the dents. What is the cure? As much as I don't want to, I would go back to ground zero if I knew it would remedy the problem. With the tabs cut, glazing, re-priming and they still come back, I fear complete redo would be in vain. I have a PDR guy that just as well be Merlin the Magician... Try pushing the dents out via glue remnants on skin??? Underside stripping post bodywork ultimately bite us??? How do we get this lazer straight again and for good???????????