B
Benny
I'm still a total novice, but I'm learning as I go with the great help on this website. Today I was shooting some SPI epoxy over bare metal, and I had a couple of spots where I applied too much product, and it created a little dimpled section.
If this happens on the first coat, should I stop completely at that point to sand it back before proceding, or can I let it flash, apply another coat over it, and sand that back? Are the dimpled areas a "weak spot" so to speak?
Thanks very much.
If this happens on the first coat, should I stop completely at that point to sand it back before proceding, or can I let it flash, apply another coat over it, and sand that back? Are the dimpled areas a "weak spot" so to speak?
Thanks very much.
