U
underdog
Not sure were to post this.
What is everyone doing for edges, ive read some take down edges to bare steel before sealing.
If so why and how, other than to keep mil down to prevent chiping.
Ive had edges to bare steel in the past and im not to happy with epoxy adhesion, unless I go around doors with a piece of 80 grit, and the epoxy is a few weeks old. But using 80 grit before I seal with epoxy seems like taking steps backwards.
Im just curios, to me edges are alway the most neglected areas, and are always the first to chip or get damaged just trying to keep everything consistant.
What is everyone doing for edges, ive read some take down edges to bare steel before sealing.
If so why and how, other than to keep mil down to prevent chiping.
Ive had edges to bare steel in the past and im not to happy with epoxy adhesion, unless I go around doors with a piece of 80 grit, and the epoxy is a few weeks old. But using 80 grit before I seal with epoxy seems like taking steps backwards.
Im just curios, to me edges are alway the most neglected areas, and are always the first to chip or get damaged just trying to keep everything consistant.