MikeS
Camaro Nut
Hello group,
Of all the care I have taken in making a temporary home made spray booth with 1 micron filters to keep dust down, I found a small eyebrow hair embedded in the clear coat while block sanding the door with P600 last night (this effort was part of the Clear Mil Thickness thread). I don't know how this got past my face mask. It's about 2/16" and curved in length. The color of the paint is Butternut Yellow and is a solid. I have tried to carefully wet sand the area but no success and I'm afraid to breaking through the clear in that section if it is indeed in the first coat.
I have an Iwata Revolution DA air brush which can make a pen point size line. Can I mist just enough butternut yellow paint over the trapped hair before I flow coat the panel without it leaving a blemish?
Thank You,
Mike
Of all the care I have taken in making a temporary home made spray booth with 1 micron filters to keep dust down, I found a small eyebrow hair embedded in the clear coat while block sanding the door with P600 last night (this effort was part of the Clear Mil Thickness thread). I don't know how this got past my face mask. It's about 2/16" and curved in length. The color of the paint is Butternut Yellow and is a solid. I have tried to carefully wet sand the area but no success and I'm afraid to breaking through the clear in that section if it is indeed in the first coat.
I have an Iwata Revolution DA air brush which can make a pen point size line. Can I mist just enough butternut yellow paint over the trapped hair before I flow coat the panel without it leaving a blemish?
Thank You,
Mike