theastronaut
Promoted Users
I'm finishing up the bodywork on the inside of a '66 F100 hood and would like to smooth the rear seam where the inner brace and outer skin overlap. The brace was removed from the skin for cleaning out trapped rust and to refit the skin to the brace to match the cowl profile better. That threw off the alignment between the flanges so there's less overlap than the original seam would've had, making the edge step shaped instead of flat. I've plug welded the two together and the fit against the cowl is good so I don't want to solid weld the seam on the edge of the flange- that would shrink the flange and throw the fit off. Is there an epoxy I could use to fill the seam and square up the edges before shooting high build? I've seen a few high end shops use Marine Tex epoxy over seams to prevent ghosting later on so I was thinking that might work for this. I've already skimmed and blocked the inner braces to make them slick so I'd like to make the rear seam as smooth as possible to match. I've never filled seams to shave them on past projects, just used seam sealer and left the seam visible, but I see show cars with filled seams all the time so I'm guessing there's a preferred product for filling them in.