Arrowhead
Oldtimer
This is a fiberglass hood with a steel liner. It's very nice and well built. However, the contour of the hood is just a little off from the fenders. I have it adjusted as best that can be done, but the hood is about a 1/8" low in the middles of both sides while flush at the front and back. Trying to figure out he best approach to leveling it. I'd rather not build up the hood with filler or fiberglass as I'll have thick areas on the side of the hood. It might almost be simpler and cleaner to cut the edge of the fender and reweld to match the contour of the hood. If it was a steel hood I could do the old 2x4 trick like the factory did to get the panels to sit flush. Ideas?
Video showing the gap:
https://plus.google.com/photos/10270...47370938946482
Video showing the gap:
https://plus.google.com/photos/10270...47370938946482