T
toofast415
shine;105 said:just kidding. if your going to sand it off i would use a jitter bug with 80 wet. mix some dawn soap and water in a good spray bottle and keep it wet enough to cut.
but the best money you could ever spend would be for a media blasting job. using acrylic you can peel it clean without harming anything else.
Sorry for the dumb question. So I'm torn between just using a DA to take the paint down to metal or using an acrylic media blaster. If I were to use the media blasting option, would I just need to hit it with my DA and 80 grit, degrease metal, then spray a coat or two of SPI epoxy? or would there be additional steps required?
Thanks,
Eddie