Ok, this is kind of new to me. I am stubburn and want this race car front end to be as factory as possible. I am installing the lights now and the molded pockets arent even close. I cut and grinded what I needed to to get the bezels in place.
Here is a pic:
Now what I want to do is basically mold around the bezel from the back side with several layers of resin and mat. and then once its hardened pul the bezel out and use 870 evercoat to do the finish shaping.
Is there a type of release agen that I can put all over the bezel to prevent the fiberglass resin from sticking to the bezel?
Here is a pic:
Now what I want to do is basically mold around the bezel from the back side with several layers of resin and mat. and then once its hardened pul the bezel out and use 870 evercoat to do the finish shaping.
Is there a type of release agen that I can put all over the bezel to prevent the fiberglass resin from sticking to the bezel?