Oil resistance of SPI epoxy primer

V

Vanishingpoint

Hi
I'm painting a raw steel enclosure for my mill. It sees a pretty good amount of water soluble coolant. Any opinions on how the epoxy would hold up without a top coat?

You know how it is with the epoxy primer...you just want to use it on everything:)

Thanks
Derek
 
Should be stronger when cured then any other coating in the Automotive refinish market.
Trick is good mils and proper cure time, for exposure although not full cured in two weeks that is the time I let set before most of my submersion tests, in thinners, dot3 etc.
 
This is a sad story, but I will tell it :) My Mustang is in a million pieces, but the parts I want to keep are in Epoxy. The other day I was walking out to cut down a small tree and the wifey call out to me, so I set my chainsaw on the trunk not paying attention to how I left it. Came back and there was a nice puddle of bar oil on the decklid. Cleaned right off with no issues so far :)
 
You must log in or register to reply here.
Back
Top