Any old laquer guys around anymore? I learned on laquer but shortly there after we switched to base/clear.
2 fenders sealed with epoxy last night
This morning I sprayed the first coat no problem. The second coat on only 1 fender decided to craze. I set it aside and will have to resand.
It's 70 degress out with 60% humidity using 65-80 degree thinner.
I sprayed the first two coats pretty wet with 15 minutes flash. 5-10 per tech sheet.
I can't remember the ins and out of spraying this stuff. This fender was the last part on a front clip that was damaged and PPG black laquer was used.
The hood did had a couple spots do this during application and I sprayed 5 wet coats with 15min between and it was pushing 80 degrees that day.
I'm going to thin my coats back but want to keep 1:1.5 mix ratio that is recommended.
Any thoughts?
2 fenders sealed with epoxy last night
This morning I sprayed the first coat no problem. The second coat on only 1 fender decided to craze. I set it aside and will have to resand.
It's 70 degress out with 60% humidity using 65-80 degree thinner.
I sprayed the first two coats pretty wet with 15 minutes flash. 5-10 per tech sheet.
I can't remember the ins and out of spraying this stuff. This fender was the last part on a front clip that was damaged and PPG black laquer was used.
The hood did had a couple spots do this during application and I sprayed 5 wet coats with 15min between and it was pushing 80 degrees that day.
I'm going to thin my coats back but want to keep 1:1.5 mix ratio that is recommended.
Any thoughts?