B
bomccorkle
I have 2k'd the car. In my blocking I have found I couple spots that are just very minorly low. I don't know that they'd even show in the finished product but I'd rather not chance it this far along. The car was shot in epoxy, filled, shot in epoxy again and then 2k'd. My plan is to sand my spots back down to epoxy then feather my glaze in. My question is what is the prefered glaze to use. My (only) local jobber(Napa) carries a 2k evercoat polyester glaze but I wasn't sure if there was one that stood above the rest. Thanks
Bo
Bo