rusty428cj
Rusty Gillis
I have been using Marson now 3M Platinum for years with no problems but lately I have had a problem. I finish the bodywork and spray with epoxy primer and wherever there is filler there are a bunch of pin holes or solvent pop. It doesn't matter if I wait 3 hours or 3 days to prime same results. Doesn't matter if sprayed in the booth or in fab shop same results and the filler is not wiped with wax and grease remover. Most of it will sand out but it looks terrible right after spraying. Anybody else had any problems now that it's 3M.