I did some searching here but I couldn't find the exact answer that I'm looking for.
For you guys that have lots of experience with Slicksand, what blocking steps (grits) do you usually use and what's the next step?
I sprayed two wet coats over 2 day old SPI epoxy, about 6 hrs later I started blocking with 120, guide coated the panels again and went over the 120 with 180. Took all the guide coat off and then some, it looks as if I removed all the 120 scratches, but I know there will be some left behind, panels feel flat, blocked my arms off, specially at the edges so I don't have a lot of primer build up.
Now my question is, what's the best way to proceed from here?
Spray 2K Regular, block 220.
Spray 2K Regular, block 400.
Seal with epoxy 1:1:1 or maybe 2K sealer 4:1:2 just before paint.
Will be a solid color btw.
Thanks in advance.
For you guys that have lots of experience with Slicksand, what blocking steps (grits) do you usually use and what's the next step?
I sprayed two wet coats over 2 day old SPI epoxy, about 6 hrs later I started blocking with 120, guide coated the panels again and went over the 120 with 180. Took all the guide coat off and then some, it looks as if I removed all the 120 scratches, but I know there will be some left behind, panels feel flat, blocked my arms off, specially at the edges so I don't have a lot of primer build up.
Now my question is, what's the best way to proceed from here?
Spray 2K Regular, block 220.
Spray 2K Regular, block 400.
Seal with epoxy 1:1:1 or maybe 2K sealer 4:1:2 just before paint.
Will be a solid color btw.
Thanks in advance.