B
Brad4321
This is currently sitting with SPI Intercoat mixed with pearl. After a couple hours of dry time I applied the decal. About 8 hours after applying the decal, to make sure it was stuck and dry, I went over the panel with SPI waterborne wax and grease to remove any of the decal adhesive and application fluid. I got these weird white streaks. It seems that the waterborne had some kind of reaction either to the pearl or the intercoat. It isn't just this one piece...it is over the entire tractor, so it is a big deal.
I wanted to bury the decals in clear, which is why I applied them at this point. I am guessing this was a little stupid and I should have sealed the intercoat in clear first, applied the decals, then applied more clear.
Did I screw up real bad and must start over, or is there a way to fix this? I am not sure what is going on.
I wanted to bury the decals in clear, which is why I applied them at this point. I am guessing this was a little stupid and I should have sealed the intercoat in clear first, applied the decals, then applied more clear.
Did I screw up real bad and must start over, or is there a way to fix this? I am not sure what is going on.