C
cstrom72
Having a issue with hazing/ cloudiness on my recent paint job. Here's what I've done, after 3 coats of clear i waited about a week because its been cool here, around 70 degrees and 40s at night. Anyway wet sanded with 800, 1000,1500 then 2000. Bought a (cheap?) 80.00 ATD variable speed buffer a wool pad and a grey finish pad. This was my first time buffing and i think i moved to fast. I used wizards turbo cut with wool, then finish cut with gray pad. The turbo cut is supposed to remove 1200 scratches.
I can still see some sand scratches in some areas, should i go back over with 2000 grit , ive been very cautious not to burn thru but i did in a couple very small spots
I have a body line that runs the length of the vehicle, part if it is only a half inch wide, i did not use the buffer in these areas because i will burn thru. Should i use a micro fiber cloth with compound and do the tight areas by hand?
I can still see some sand scratches in some areas, should i go back over with 2000 grit , ive been very cautious not to burn thru but i did in a couple very small spots
I have a body line that runs the length of the vehicle, part if it is only a half inch wide, i did not use the buffer in these areas because i will burn thru. Should i use a micro fiber cloth with compound and do the tight areas by hand?