Touch up gun for small epoxy jobs?

  • Thread starter Professionalamateur
  • Start date
P

Professionalamateur

I was wondering if a Campbell Hausfeld siphon feed touch (DH5500) up gun would be acceptable to spray epoxy. I need to spray awkward areas in the trunk and wheel wells before I weld in my trunk floor. Most of the areas I intend to spray will either stay epoxy or covered with bed liner. Any input for settings would be great also.

Thanks!
 
Yup, it will work, dial in your settings on a piece of scrap. You'll probably want 25-30ish psi then starting with your trigger travel adjustment all the way in turn it out untill it lays a thin wet coat.
 
i even force it unreduced through my little iwata airbrush for real small touch ups..it just has to be warm, air pressure high!
 
You must log in or register to reply here.
Back
Top