H
HIG
We would like to dress us the stock valve cover on my son's Jeep, we will be spraying SPI red then Universal Clear. Is there a way to highlight the raised lines on top of it?
I thinks it's done a lot on Ford valve covers. We've been using white epoxy as a sealer then the red base, could we wet sand the red off from the lines then clear over everything? I'm assuming it's an aluminum valve cover. Would the white sealer show if we sanded it from the lines, what grits should we use, etc... I'd rather not have to mask it if possible.
You guys have any suggestions?
Thanks, Steve
I thinks it's done a lot on Ford valve covers. We've been using white epoxy as a sealer then the red base, could we wet sand the red off from the lines then clear over everything? I'm assuming it's an aluminum valve cover. Would the white sealer show if we sanded it from the lines, what grits should we use, etc... I'd rather not have to mask it if possible.
You guys have any suggestions?
Thanks, Steve