Will my 6" DA polisher be enough.

[jcclark]

I wash mine out with a garden hose, then spin them on the buffer,
and let them dry.

 

[64avanti]

I wash mine in the laundry tub with Dawn dish soap and a scrub brush, then spin them dry with my buffer. I hold it in an empty garbage can so I stay dry.

 

[Tungsten]

Thanks guys. I just washed it with soap and water. Looks clean again. Did a nice job compared to my RO. Only 3/4 of the truck left to do.arg

 

[ls60apache]

Thanks guys. I just washed it with soap and water. Looks clean again. Did a nice job compared to my RO. Only 3/4 of the truck left to do.arg View attachment 26281View attachment 26282

So fired up the rotary. Was cautious so ran it on 2 to spread some goo around. I can see how this can do some damage.
Just been going slowly on speed 3 back and forth a little. Really looks nice so far.

Question how much do I need to keep adding to the wool pad? Is there a point where it’s full? See pic. I’ve added so far twice 4 lines in a cross thanks. View attachment 26267

lh
Looking good... along with all the other good advice I would also get a table to put your buffer and compound on.. possibly a few grits could get kicked up on the pad lying on the ground...that would make a bad day with all the hard work you put in.