MDPotter
Promoted Users
I've been searching around and haven't found a thread that addresses my particular situation:
I just bought the CG V32, 34, 36, 38 kit along with the orange, white, and black hexalogic pads. I have a 6" RO sander as well.
From what I've read, for the best finish, I should sand with 1000/1200/1500/2000/2500/3000 (all wet).
Here are my questions:
1) Where can I buy this sandpaper? I would like it to all be the same manuf and purchased from the same source, but if not that's okay too. I also don't want to buy a huge quantity as I don't sand and polish hardly ever.
2) Which of these grits should be done by hand and which with an interface pad on an RO?
3) After finishing with 3000, should I use the orange pad with 32 or 34?
4) After the orange pad with 32 or 34, go to 36 with white pad?
5) Final step 38 with black pad?
I just bought the CG V32, 34, 36, 38 kit along with the orange, white, and black hexalogic pads. I have a 6" RO sander as well.
From what I've read, for the best finish, I should sand with 1000/1200/1500/2000/2500/3000 (all wet).
Here are my questions:
1) Where can I buy this sandpaper? I would like it to all be the same manuf and purchased from the same source, but if not that's okay too. I also don't want to buy a huge quantity as I don't sand and polish hardly ever.
2) Which of these grits should be done by hand and which with an interface pad on an RO?
3) After finishing with 3000, should I use the orange pad with 32 or 34?
4) After the orange pad with 32 or 34, go to 36 with white pad?
5) Final step 38 with black pad?